Roland VP-770 用户手册
59
Use the cursor buttons and the value dial to change the value.
In the screen, Sw1 indicates the [S1] button’s assignment, and Sw2 indicates the [S2] button’s
assignment.
assignment.
Parameter
Value
Description
Source
REGIST, SYSTEM
The assignments for the [S1]/[S2] buttons can be stored individually in each registration. When
you select a diff erent registration, this setting specifi es whether the [S1]/[S2] buttons will be
given the assignments stored in the registration (REGIST), or the assignments stored in the
system settings for the entire VP-770 (SYSTEM).
you select a diff erent registration, this setting specifi es whether the [S1]/[S2] buttons will be
given the assignments stored in the registration (REGIST), or the assignments stored in the
system settings for the entire VP-770 (SYSTEM).
ASSIGN
Specify the functions that will be controlled by the [S1]/[S2] buttons.
OFF
Off
PIZZ/STAC
The pizzicato or staccato sound will be heard (only for supported tones).
FALL/TREM
The fall or tremolo sound will be heard (only for supported tones).
UNI/STK
Switches between unison mode and stack mode (only for supported tones).
DOIT
Applies the doit eff ect (only for supported tones).
PORT-ENS
Applies the portamento eff ect to the Ensemble.
PORT-VOC
Applies the portamento eff ect to the Vocal Designer.
AMB-OFF
Switches the ambience when you press the button.
DIR-MIC-OFF
Switches the direct microphone when you press the button.
MODE
Turns the [S1]/[S2] buttons function LATCH/MOMENTARY.
LATCH
The on/off status will alternate each time you press [S1]/[S2] button.
MOMENTARY
The status will be on only while you hold down [S1]/[S2] button.
If you want to save your settings, press the [F2] (WRITE or SYS WRITE)
button.
button.
For details on saving your settings, refer to “Saving a Registration” (p. 81) or “Saving the System Settings”
(p. 96).
When you’ve fi nished making settings, press the [EXIT] button.
System Settings and Registrations
The system parameters are a single set of settings that apply in common to the entire VP-770. They include
settings such as those for the keyboard sensitivity, master tuning, and MIDI.
Registrations allow you to save settings that select sounds and specify panel settings.
For some controllers (aftertouch, pedal, [S1] /[S2] buttons, D Beam), the settings can be stored either as
system settings for the entire VP-770 or for individual registrations.
Use the system parameter “Source” to specify which setting you want to use.
For example, if you want the [S1]/[S2] buttons to always have the same function even when you switch
registrations, you should set the Source as “SYSTEM.” If you want the [S1]/[S2] buttons to change their
function when you switch registrations, set the Source to “REGIST.”
2.
✍
3.
4.