TANDBERG D50104-15 用户手册

98

Health Care System III

Appendix 5

It is possible to access a file system within the TANDBERG system by using ftp:
DOS-window:

ftp <IP-address of codec>, or

Web-browser:

ftp:// <IP-address of codec>

Description of the different files
all.prm

- all settings in the system (including directory)

dir.prm

- directory entries

event.log - logs fault sitations etc.
sw.pkg

- the system software

Description of the different folders
user

- a folder to be used for custom logos etc.

remote

- a folder used for software upgrade of the far end TANDBERG system

What can be done by using the file system?
· software upgrade of the far end TANDBERG system (B3 or above) via ISDN
· upload of custom logos

Software upgrade
· Connect to the system you want to upgrade using ISDN.
· Copy the software file to a folder on your harddisk.
· Open a DOS-window and go to this folder.
· Type ftp <IP-address of your local codec).
· Enter password: <Release Key of far end system>
· Go to the remote folder, type “cd remote”
· Upload the software file, type put <s0xxxxxx.pkg>
· Wait until the following is shown:

226 Closing data connection.

5437569 bytes sent in 808.01 seconds (6.73 Kbytes/sec)

ftp>

· Restart the far end codec.
The far end system should now be upgraded. For further information, please contact your TANDBERG representative.

Custom logos
· Go to the folder where your logo is located.

NOTE:  Logo max size: 320x200, or max. 64000 pixels and must be in jpg-format. If the file is too large, no logo will be displayed.

· Type ftp <IP-address of your local codec).
· Go to the user folder, type “cd user”
· Upload the logo, type put <startup.jpg>
The new logo will be displayed the next time you restart your system.