Philips S1D13505 用户手册
Page 38
Epson Research and Development
Vancouver Design Center
S1D13505
Programming Notes and Examples
X23A-G-003-07
Issue Date: 01/02/05
6 LCD Power Sequencing and Power Save Modes
The S1D13505 design includes a pin (LCDPWR) which may be used to control an external
LCD bias power supply. If the hardware design makes use of LCDPWR, automatic LCD
power sequencing and power save modes are available to the programmer. If LCDPWR is
not used to control an external LCD bias power supply, this section is not applicable.
LCD bias power supply. If the hardware design makes use of LCDPWR, automatic LCD
power sequencing and power save modes are available to the programmer. If LCDPWR is
not used to control an external LCD bias power supply, this section is not applicable.
6.1 LCD Power Sequencing
The S1D13505 is designed with internal circuitry which automates LCD power sequencing
(the process of powering-on and powering-off the LCD panel). LCD power sequencing
allows the LCD bias voltage to discharge prior to shutting down the LCD signals. Power
sequencing prevents long term damage to the panel and avoids unsightly “lines” at power-
on/power-off.
(the process of powering-on and powering-off the LCD panel). LCD power sequencing
allows the LCD bias voltage to discharge prior to shutting down the LCD signals. Power
sequencing prevents long term damage to the panel and avoids unsightly “lines” at power-
on/power-off.
Proper LCD power sequencing for power-off requires a time delay from the time the LCD
power is disabled to the time the LCD signals are shut down. Power-on requires the LCD
signals to be active prior to applying power to the LCD. This time interval varies depending
on the LCD bias power supply design. For example, the LCD bias power supply on the
S5U13505 Evaluation board requires approximately 0.5 seconds to fully discharge. Your
power supply design may vary.
power is disabled to the time the LCD signals are shut down. Power-on requires the LCD
signals to be active prior to applying power to the LCD. This time interval varies depending
on the LCD bias power supply design. For example, the LCD bias power supply on the
S5U13505 Evaluation board requires approximately 0.5 seconds to fully discharge. Your
power supply design may vary.
For most applications internal power sequencing is the appropriate choice. However, there
may be situations where the internal time delay is insufficient to discharge the LCD bias
power supply before the LCD signals are shut down. For the sequence used to manually
power-off the LCD panel, see Section 6.1.2, “LCD Power Disable” on page 39.
may be situations where the internal time delay is insufficient to discharge the LCD bias
power supply before the LCD signals are shut down. For the sequence used to manually
power-off the LCD panel, see Section 6.1.2, “LCD Power Disable” on page 39.
6.1.1 Registers
The LCD Enable bit triggers all automatic power sequencing.
Setting the LCD Enable bit to 1 causes the S1D13505 to enable the LCD display. The
following sequence of events occurs:
following sequence of events occurs:
1. Confirms the LCD power is disabled.
2. Enables the LCD signals.
3. Counts 128 frames.
4. Enables the LCD power.
REG[0Dh] Display Mode Register
SwivelView
Enable
Enable
Simultaneous
Display
Option Select
Bit 1
Display
Option Select
Bit 1
Simultaneous
Display
Option Select
Bit 0
Display
Option Select
Bit 0
Bit-Per-Pixel
Select Bit 2
Select Bit 2
Bit-Per-Pixel
Select Bit 1
Select Bit 1
Bit-Per-Pixel
Select Bit 0
Select Bit 0
CRT Enable
LCD Enable