Panasonic CF-VDL02BM 用户手册

Check the cable connection to the LCD Monitor.
Confirm that the [Serial Port] has not been set to [Dis-
able] in the Setup Utility.
Confirm that the setting for resource in [UPDD]*

1

 - [Set-

tings] - [Hardware] and the setting of the Serial Port in the
Setup Utility are the same.

*

1

: [start] - [All Programs] - [UPDD]

: [Start] - [Programs] - [UPDD]

The mode not supported has been selected.
Set the display mode to 640 × 480  60 Hz, 800 × 600  60
Hz or 1024 × 768 60 Hz.
Check the cable connection to the LCD Monitor.
Select 

 on the OSD main menu and perform fine

adjustments. (

 page 15)

Select 

 from the OSD main menu, then select [Init

NVRam], then press 

.

Select [Yes], then press 

.

Turn off the power to the LCD Monitor and then turn the
power back on again. (

 page 16)