Baldor E100 用户手册
www.supportme.net
Configuration 6-1
MN1942
6.1 Introduction
Before powering the MicroFlex e100 you will need to connect it to the PC using a USB or Ethernet
cable and install the supplied Mint Machine Center software. This software includes a number of
tools to allow you to configure and tune the MicroFlex e100. If you do not have experience of
software installation or Windows applications you may need further assistance for this stage of
the installation.
cable and install the supplied Mint Machine Center software. This software includes a number of
tools to allow you to configure and tune the MicroFlex e100. If you do not have experience of
software installation or Windows applications you may need further assistance for this stage of
the installation.
6.1.1 Connecting the MicroFlex e100 to the PC
The MicroFlex e100 can be connected to the PC using either USB or TCP/IP.
To use USB, connect a USB cable between a PC USB port and the MicroFlex e100 USB port.
Your PC must be using Windows 2000 or Windows XP.
Your PC must be using Windows 2000 or Windows XP.
To use TCP/IP, connect a CAT5 Ethernet cable between the PC and one of the MicroFlex e100
Ethernet ports.
Ethernet ports.
CAUTION: You cannot connect an ordinary office PC to the MicroFlex e100 without first
altering the PC’s Ethernet adapter configuration. However, if you have
installed a second Ethernet adapter dedicated for use with the
MicroFlex e100, then this adapter’s configuration can be altered without
affecting the PC’s office Ethernet connection. If you are unsure about
making changes to your PC’s Ethernet adapter configuration, or are
prevented by user permission levels, ask your I.T. administrator to assist
you.
installed a second Ethernet adapter dedicated for use with the
MicroFlex e100, then this adapter’s configuration can be altered without
affecting the PC’s office Ethernet connection. If you are unsure about
making changes to your PC’s Ethernet adapter configuration, or are
prevented by user permission levels, ask your I.T. administrator to assist
you.
CAUTION: If there is a EPL manager node (node ID 240) on the Ethernet network, then
the network will be operating in EPL mode. This means any TCP/IP
connection from the PC must pass through an EPL compatible router.
connection from the PC must pass through an EPL compatible router.
6.1.2 Installing Mint Machine Center and Mint WorkBench
You will need to install Mint Machine Center (MMC) and Mint WorkBench to configure and tune
the MicroFlex e100. Any previous version of Mint WorkBench must be uninstalled before
proceeding with this installation:
the MicroFlex e100. Any previous version of Mint WorkBench must be uninstalled before
proceeding with this installation:
1. Insert the CD into the drive.
2. After a few seconds the setup wizard should start automatically. If the setup wizard does not
appear, select Run... from the Windows Start menu and type
d:\start
where d represents the drive letter of the CD device.
Follow the on-screen instructions to install MMC (including Mint WorkBench). The setup
wizard will copy the files to appropriate folders within the C:\Program Files folder, and place
shortcuts on the Windows Start menu.
wizard will copy the files to appropriate folders within the C:\Program Files folder, and place
shortcuts on the Windows Start menu.
6
Configuration
6