National Instruments 3.x 用户手册

Follow proper ESD precautions to ensure you are grounded before installing the 

hardware.

The NI CompactFlash device supports hot insertion on a PDA device, 
which means you can install and remove the NI CompactFlash device 
without rebooting the PDA device. You can install an NI CompactFlash 
device in any available Type II CompactFlash slot.

To install the NI CompactFlash device, refer to the following figure while 
completing the following steps.

1.

NI CompactFlash devices have two connectors: a 50-pin 
CompactFlash bus connector on one end, and an I/O connector on the 
other. The NI CompactFlash device is keyed so that you can insert it 
only one way. Insert the NI CompactFlash device in the slot until the 
connector is firmly seated.

Always grasp the device by the connectors you are inserting or removing. 

Never pull directly on the I/O to unplug it from the NI CompactFlash device.

1

PDA with Type II CompactFlash Slot

2

NI CompactFlash Device

3

I/O Cable

4

Accessory

5

I/O Signals

1

2

3

4

5