Niles Audio TS-1 用户手册
I
N T E L L I
P
A D
®
C i
T
O U C H
S
C R E E N
K
E Y P A D
25
Installing the TS-1 in New Construction
For a new construction site, use our optional New Construction Bracket (FG01060) to provide a
support for mounting the TS-1 on new drywall, as shown in Figure 14.
support for mounting the TS-1 on new drywall, as shown in Figure 14.
Figure 14
Using the optional New Construction Bracket (FG01060) to install a TS-1 in new construction.
continued on next page...
I
N T E L L I
P
A D
®
C i
T
O U C H
S
C R E E N
K
E Y P A D
24
INSTALLATION CONSIDERATIONS (continued)
Installing the TS-1 in Existing Construction
1. At a proposed site, use the enclosed wall template to mark the outline of the TS-1. Check for
hidden obstructions by drilling a small hole in the drywall at the center of the outline. If you
feel any obstructions while drilling, stop immediately and select another site.
feel any obstructions while drilling, stop immediately and select another site.
2. Bend a piece of stiff wire (e.g., coat hanger) about 6 inches from the end at a 90-degree angle.
Insert the bent end into the hole and rotate the wire to check if there are any other obstruc-
tions. If you hit anything, patch the hole with drywall compound and choose another site.
tions. If you hit anything, patch the hole with drywall compound and choose another site.
3. Connect the CAT-5 cable(s) to the TS-1’s rear jack(s) (see Connecting the TS-1 on page 27).
IMPORTANT: Test cable prior to connection, miswired and damaged cables can cause dam-
age to the TS-1.
age to the TS-1.
4. The TS-1 is equipped with two Mounting Clamps for easy installation. Hold the TS-1 firmly in
the opening and use a Phillips screwdriver to turn each mounting-clamp screw to the right
until the TS-1 feels fastened, as shown in Figure 13.
until the TS-1 feels fastened, as shown in Figure 13.
NOTE: Do not overtighten the mounting-clamp screws.
Figure 13
Using the TS-1’s built-in mounting clamps.