Motorola Embedded Controller 用户手册
Installation Instructions
2-15
2
IP Installation on the MVME162LX
Up to two IPs may be installed on the 700/800-series MVME162LX.
Install the IPs on the board as follows:
Install the IPs on the board as follows:
1. Each IP has two 50-pin connectors that plug into two
corresponding 50-pin connectors on the MVME162LX: J5/J6,
J7/J8. See Figure 2-1 for the MVME162LX connector
locations.
J7/J8. See Figure 2-1 for the MVME162LX connector
locations.
Ð Orient the IP(s) so that the tapered connector shells mate
properly. Plug IP_a into connectors J5 and J6; plug IP_b
into J7 and J8. If a double-sized IP is used, plug IP_ab into
J5, J6, J7, and J8.
into J7 and J8. If a double-sized IP is used, plug IP_ab into
J5, J6, J7, and J8.
2. Two additional 50-pin connectors (J3 and J4) are provided
behind the MVME162LX front panel for external cabling
connections to the IP modules. There is a one-to-one
correspondence between the signals on the cabling
connectors and the signals on the associated IP connectors
(i.e., J4 has the same IP_a signals as J5; J3 has the same IP_b
signals as J7).
connections to the IP modules. There is a one-to-one
correspondence between the signals on the cabling
connectors and the signals on the associated IP connectors
(i.e., J4 has the same IP_a signals as J5; J3 has the same IP_b
signals as J7).
Ð Connect user-supplied 50-pin cables to J3 and J4 as
needed. Because of the varying requirements for each
different kind of IP, Motorola does not supply these
cables.
different kind of IP, Motorola does not supply these
cables.
Ð Bring the IP cables out the narrow slot in the MVME162LX
front panel and attach them to the appropriate external
equipment, depending on the nature of the particular
IP(s).
equipment, depending on the nature of the particular
IP(s).