Motorola MVME3100 用户手册
Chapter 3 MOTLoad Firmware
MVME3100 Single-Board Computer Installation and Use (V3100A/IH1)
27
■
Edits VMEbus Register Access Image Control Register state
vmeCfg –e –rF70
Deleting VME Settings
To delete the changeable VME setting (restore default value), type the following at the firmware
prompt:
prompt:
■
Deletes Master Enable state
vmeCfg –d –m
■
Deletes selected Inbound Window state
vmeCfg –d –i(0 - 7)
■
Deletes selected Outbound Window state
vmeCfg –d –o(0 - 7)
■
Deletes PCI Miscellaneous Register state
vmeCfg –d –r184
■
Deletes Special PCI Target Image Register state
vmeCfg –d –r188
■
Deletes Master Control Register state
vmeCfg –d –r400
■
Deletes Miscellaneous Control Register state
vmeCfg –d –r404
■
Deletes User AM Codes Register state
vmeCfg –d –r40C
■
Deletes VMEbus Register Access Image Control Register state
vmeCfg –d –rF70
Restoring Default VME Settings
To restore all of the changeable VME setting back to their default settings, type the following at
the firmware prompt:
the firmware prompt:
vmeCfg –z
Remote Start
, remote start allows the user to obtain information about the target board,
download code and/or data, modify memory on the target, and execute a downloaded program.
These transactions occur across the VMEbus in the case of the MVME3100. MOTLoad uses
one of four mailboxes in the Tsi148 VME controller as the inter-board communication address
(IBCA) between the host and the target.
These transactions occur across the VMEbus in the case of the MVME3100. MOTLoad uses
one of four mailboxes in the Tsi148 VME controller as the inter-board communication address
(IBCA) between the host and the target.