National Instruments 1142 用户手册

© National Instruments Corporation

Refer to the SCXI Quick Start Guide for information on verifying the SCXI 
installation.

Refer to the SCXI Quick Start Guide for information on installing chassis 
and modules using NI-DAQmx in software.

If the self-test verification did not verify the chassis configuration, 
complete the steps in this section to troubleshoot the SCXI configuration.

•

If you get a Verify SCXI Chassis message box showing the SCXI 
chassis model number, Chassis ID: x, and one or more messages 
stating Slot Number: x Configuration has module: SCXI-XXXX 
or 1141/1142/1143, hardware in chassis is: Empty, take the 
following troubleshooting actions:

–

Make sure the SCXI chassis is powered on.

–

Make sure all SCXI modules are properly installed in the chassis. 
Refer to the SCXI Quick Start Guide for proper installation 
instructions.

–

Make sure the cable between the SCXI chassis and E/M Series 
DAQ device is properly connected.

–

Inspect the cable connectors for bent pins.

–

Make sure you are using the correct NI cable assembly.

–

Test the E/M Series DAQ device to verify it is working properly. 
Refer to the E/M Series DAQ device help file for more 
information.