National Instruments 1142 用户手册

© National Instruments Corporation

removing

requirements for getting started, 1-2
ripple, real filters, 4-6
RTD

safety specifications, A-6
SCAN CLK signal

SCXI chassis

SCXI-1141/1142/1143

calibration, 5-13
common software settings, 3-1
configuration settings, 3-1
dimensions (figure), A-5
documentation, 1-2
hardware, 1-2
measurements, 3-3
software, 1-2
using

SCXI-1141/1142/1143 modules

See also configuration, installation
block diagram, 4-2
overview, 1-1
requirements for getting started, 1-2

SCXIbus communication signals

emulation by digital I/O signal lines, 2-11
SCXIbus to SCXI-1141/1142/1143 pin 

self-test verification, troubleshooting, 1-5
SER CLK signal

SER DAT IN signal

SER DAT OUT signal

setting cutoff frequency for lowpass filters. See 

cutoff frequency for lowpass filters

signal connections

front connector

analog input channels, 2-3
digital input and output, 2-6
signal descriptions (table), 2-3

front signal connector

rear signal connector

signals

SLOT 0 SEL* signal

software