Microsoft G7VP2 用户手册

Hardware Installation

2.9.5 Floppy Disk Drive Controller

1. Install the 34-pin header

connector into the shrouded

floppy disk header (J11) on

the system board. The

colored edge of the ribbon

should be aligned with pin 1

of connector J11.

2. Install the other 34-pin

header connector(s) into the

disk drive(s). Align the

colored edge of the daisy

chained ribbon cable with

pin 1 of the drive edge connector(s). The end-most connector

should be attached to the drive you want to designate as Drive

2.9.6 IDE Hard Disk Interface

1. If you are connecting

two hard drives, install

the 40-pin connector of

the IDE cable into the

primary shrouded IDE

header (connector J10).

If you are adding a third

or fourth IDE device,

install the 40-pin

connector of the other

IDE cable into the

secondary shrouded IDE

header (connector J12).

2. Install the other 40-pin header connector(s) into the device with

the colored edge of the ribbon cable aligned with pin 1 of the

drive edge connector(s).

Note:

Refer to your disk drive users manual for information about

selecting proper drive switch settings.