Microsoft G7VP2 用户手册

Hardware Installation

2.9.11 J13 (LEDs and Switches)

SP-LED - ATX 5VSB Standby LED

This LED will light when the 5VSB power is active.

ATX-SW - ATX Power Switch

Depending on the setting in the BIOS setup, this switch is a dual

function power button that will allow your system to enter the Soft-

Off or Suspend mode. Refer to Soft-Off By PWRBTN in the Power

Management Setup (Chapter 3) of the Award BIOS.

HD-LED - Primary/Secondary IDE LED

This LED will light when the hard drive is being accessed.

G-LED - Green LED

This LED will light when the system is in the Suspend mode.

G-SW - Green Switch

This switch will allow your system to enter the Suspend mode. To

wake up the system, PM Events in the Power Management Setup

(Chapter 3) must be enabled so that access to the specified IRQ

will allow the system to wake up completely from the Suspend

mode.

H-RST - Reset Switch

This switch allows you to reboot without having to power off the

system thus prolonging the life of the power supply or system.

SPEAKER - Speaker Connector

This connects to the speaker installed in the system chassis.