National Instruments PCI 用户手册
Chapter 2
PCI Serial Hardware Installation, Verification, and Configuration
© National Instruments Corporation
2-21
Configure Communication Port Settings
The serial configuration utility is fully integrated into the Windows NT
Control Panel. You can use it to view or change the configuration of your
serial ports.
Control Panel. You can use it to view or change the configuration of your
serial ports.
To configure a serial port, complete the following steps:
1.
Select Start»Settings»Control Panel and double-click on the niports
icon. A list of installed National Instruments ports appears, as shown
in Figure 2-10.
icon. A list of installed National Instruments ports appears, as shown
in Figure 2-10.
Figure 2-10. niports Configuration Utility
2.
Select the port that you want to configure and refer to the following
instructions:
instructions:
•
To remove hardware information about the port from
Windows NT, click on the Delete button. You should do this
before you remove your hardware.
Windows NT, click on the Delete button. You should do this
before you remove your hardware.
•
To view or change the port settings, click on the Settings button.
For more information about the settings, refer to the next section,
For more information about the settings, refer to the next section,
•
In the General Port Settings dialog box, click on the Resources
button to view the resources for the port.
button to view the resources for the port.