Cisco Systems IAD2430 用户手册

Make sure to use the correct screws for this mounting option (see 

).

Screws are included for attaching the brackets to the chassis, but not for installing the chassis in a rack 
or on a wall. You need four additional machine screws to install the chassis in a rack. Use the screw size 
required by your rack. After the brackets are secured to the chassis, you can rack-mount the chassis. 

Using screws that you provide, attach the chassis to the rack as shown in 

.

The following warning applies only when the unit is wall-mounted:

This unit is intended to be mounted on a wall. Please read the wall-mounting instructions carefully 
before beginning installation. Failure to use the correct hardware or to follow the correct procedures 
could result in a hazardous situation to people and damage to the system. Statement 248

You can wall-mount the Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IAD with either the right 
side or the left side facing up; however, the front and back panels must be vertical.

To wall-mount the chassis, follow this procedure:

Attach the short side of one bracket to the chassis, as shown in 

, using two 6-32 x 1/4 slotted 

hex screws (provided). Be sure to use a plastic washer (provided) with each screw; the narrow end of the 
washer must fit into the bracket slot, facing the chassis.

88969