Cisco Systems IAD2430 用户手册

The following message appears at the end of the boot-up messages:

--- System Configuration Dialog ---

Continue with configuration dialog? [yes/no]:

Enter no to proceed with manual configuration by using the command-line interface (CLI):

Would you like to enter the initial configuration dialog? [yes/no]: no

Would you like to terminate autoinstall? [yes]

Press Return to terminate autoinstall and continue with manual configuration.

Several messages appear, ending with lines similar to the following:

Copyright (c) 2008 by cisco Systems, Inc.

Compiled <date> <time> by <person>

Press Return to bring up the Router> prompt:

flashfs[4]: Initialization complete.

Router>

Enter privileged EXEC mode:

Router> enable 

Router#

Continue with the, 

.

If the 

rommon 1> 

prompt appears, your system has booted in ROM monitor mode. For information on 

the ROM monitor, see the router rebooting and ROM monitor information in the 

 for your Cisco IOS software release.

This section describes how to prepare the Cisco IAD2430 IAD series IAD to perform basic 
communication functions. You may initially configure your router by using the Cisco IOS 
command-line interface (CLI) or by using the setup command facility. To create the initial 
configuration, the setup command facility prompts you for basic information about your router and 
network.

If you ordered your Cisco IAD2430 series IAD with the Simple Network-Enabled Auto-Provision 
(SNAP) option, no on-site configuration is required. If the Cisco IAD is connected to the WAN, the 
SNAP application downloads and installs the applicable files, and configures the Cisco IAD 
automatically. No additional configuration should be required. For additional information about SNAP, 
see the 

feature module at the 

following URL: