Cisco Systems 2500 用户手册
13
Step 3
Place the switch on the table or shelf near an AC power source.
Note
Allow 3 inches of space around the controller ventilation openings to prevent airflow
restriction and overheating.
restriction and overheating.
Step 4
After the controller is mounted on a shelf or desk, perform the following tasks to complete
the installation:
the installation:
•
•
•
Step 5
For configuration instructions about using the CLI setup program, see the
Mounting the Controller on a Wall (Rack-Mount Brackets)
The controller can be mounted on a wall using an optional rack-mount bracket kit that is not included
with the controller. You can order a kit with 19-inch rack mounting brackets and hardware from
Cisco. The kit part number is AIR-CT2504-RMNT.
with the controller. You can order a kit with 19-inch rack mounting brackets and hardware from
Cisco. The kit part number is AIR-CT2504-RMNT.
Warning
Read the wall-mounting carefully before beginning installation. Failure to use the
correct hardware or to follow the correct procedures could result in a hazardous
situation to people and damage to the system. Statement 378
correct hardware or to follow the correct procedures could result in a hazardous
situation to people and damage to the system. Statement 378
To mount the controller on a wall using rack-mount brackets, follow these steps:
Step 1
Attach the 19-inch brackets to each side of the 2504 controller as shown in
with
#10-32 flat head screws provided in the kit.