Sun Microsystems 60 用户手册

Chapter 8

Major Subassemblies

8-11

8.4

Cable Assemblies

To remove and replace the peripheral power cable assembly and the diskette drive
cable assembly, proceed as follows.

Note –

Unconnected peripheral power cables should remain clipped inside the

main chassis.

8.4.1

Removing the Peripheral Power Cable Assembly

1. Power off the system unit.

See Section 6.2, “Powering Off the System Unit” on page 6-3.

2. Remove the side access cover.

Caution –

Use proper ESD grounding techniques when handling components. Wear

an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.

3. Attach the wrist strap.

See Section 7.2, “Attaching the Wrist Strap” on page 7-3.

4. Disconnect the peripheral power cable assembly as follows:

a. Remove the peripheral power cable connector from the power supply.

b. Partially remove the drive tray.

See Section 9.2.1, “Removing the RMA” on page 9-4.

c. Remove the peripheral power cable connector from the CD-ROM drive (or tape

drive) and the diskette drive.

d. Remove the peripheral power cable connector from the hard drive SCSI

subassembly.

5. Remove the peripheral power cable from the cable routing clips.

6. Remove the peripheral power cable assembly.