Sun Microsystems 60 用户手册
4-10
Sun Ultra 60 Service Manual • August 2001
4.6.3
probe-scsi
and
probe-scsi-all
probe-scsi
transmits an inquiry command to internal and external SCSI devices
connected to the system unit on-board SCSI interface. If the SCSI device is connected
and active, the target address, unit number, device type, and manufacturer name is
displayed.
and active, the target address, unit number, device type, and manufacturer name is
displayed.
probe-scsi-all
transmits an inquiry command to SCSI devices
connected to the system SCSI host adapters. The first identifier listed in the display
is the SCSI host adapter address in the system device tree followed by the SCSI
device identification data.
is the SCSI host adapter address in the system device tree followed by the SCSI
device identification data.
identifies the
probe-scsi
output message and
the
probe-scsi-all
output message.
CODE EXAMPLE 4-3
watch-net-all
Output Message
{0} ok watch-net-all
/pci@1f,4000/network@1,1
Hme register test --- succeeded.
Internal loopback test -- succeeded.
Transceiver check -- Using Onboard Transceiver - Link Up.
passed
Using Onboard Transceiver - Link Up.
Looking for Ethernet Packets.
‘.’ is a Good Packet. ‘X’ is a Bad Packet.
Type any key to stop.
...
CODE EXAMPLE 4-4
probe-scsi
Output Message
ok probe-scsi
Target 0
Unit 0 Disk QUANTUM VK4550J SUN4.2G8600
Target 6
Unit 0 Removable Read Only device TOSHIBA
XM5701TASUN12XCD0997
CODE EXAMPLE 4-5
probe-scsi-all
Output Message
{0} ok probe-scsi
Target 0
Unit 0 Disk QUANTUM VK4550J SUN4.2G8600