Samsung 164BX 用户手册
Memory and Microprocessor Configuration
5–5
Increasing Microprocessor Speed
5.3.3 Removing the 21164 Microprocessor
Remove the microprocessor currently in place at location U55 by performing the
following steps:
following steps:
1.
Unplug the fan power/sensor cable from connector J35 (see Figure 2–1).
2.
Remove the four 6-32
X
0.875-inch screws that secure the fan and fan guard to
the heat sink.
3.
Remove the fan and fan guard.
4.
If the sink/chip/fan clip is used, remove it by unhooking its ends from around the
ZIF socket retainers.
ZIF socket retainers.
5.
Using a 7/16-inch socket, remove the two nuts securing the heat sink to the
microprocessor studs.
microprocessor studs.
6.
Remove the heat sink by gently lifting it off the microprocessor.
7.
Remove and discard the GRAFOIL heat conduction pad.
8.
Thoroughly clean the bottom surface of the heat sink before affixing it to the
new microprocessor.
new microprocessor.
9.
Lift the ZIF socket actuator handle to a full 90° angle.
10. Remove the microprocessor chip by lifting it straight out of the socket.
5.3.4 Installing the 21164 Microprocessor
Install the new microprocessor in location U55 by performing the following steps:
Note:
Install the heat sink only after the microprocessor has been assembled to
the ZIF socket.
the ZIF socket.
1.
Observe antistatic precautions.
2.
Lift the ZIF socket actuator handle to a full 90° angle.
3.
Ensure that all the pins on the microprocessor package are straight.
4.
The ZIF socket and microprocessor are keyed to allow for proper installation.
Align the microprocessor, with its missing AD01 pin, with the corresponding
plugged AD01 position on the ZIF socket. Gently lower into position.
Align the microprocessor, with its missing AD01 pin, with the corresponding
plugged AD01 position on the ZIF socket. Gently lower into position.
5.
Close the ZIF socket actuator handle to its locked position.