Lucent Technologies R5SI 用户手册
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-122
ANNOUNCE (Announce)
10
ANNOUNCE (Announce)
The ANNOUNCE MO logs an error in the hardware error log if at least one of the
following is true:
following is true:
■
The
save announcements
or
restore announcements
command does
not complete successfully, or the
■
System fails to restore announcements from the memory card [386
system] or tape [286 system] at boot time.
system] or tape [286 system] at boot time.
Figure 10-4 shows the connection of the Announcement Circuit Pack to the
system. To save or restore announcements, an ANNOUNCEMENT Data
Extension must be administered, and at least one DATA-CHL (Network Control
Data Channel) must be in the in-service/idle state.
system. To save or restore announcements, an ANNOUNCEMENT Data
Extension must be administered, and at least one DATA-CHL (Network Control
Data Channel) must be in the in-service/idle state.
Figure 10-4.
Connection of Announcement Circuit Pack to the System
MO Name (in
Alarm Log)
Alarm Level
Initial Command
to Run
Full Name of MO
ANNOUNCE
none
none
ANNOUNCEMENT
MEMORY BUS
DATA-CHL
SOFTWARE
DATA-CHL
SOFTWARE
DATA-CHL
SOFTWARE
DATA-CHL
SOFTWARE
PR-MAINT
TAPE
DRIVE
PROCESSOR
SWITCH
SOFTWARE
APPLICATIONS
ANNOUNCEMENT
CIRCUIT PACK
TDM BUS
NETWORK CONTROL
DATA
CHL2
DATA
CHL1
DATA
CHL3
DATA
CHL4
CARD-MEM