Lucent Technologies R5SI 用户手册

下载
页码 2643
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si  
555-230-123  
Issue 1
April 1997
Maintenance Object Repair Procedures 
Page 10-868
MEM-BD (Memory) 
10
MEM-BD (Memory)
NOTE:
For memory problems on systems with a TN790 RISC processor circuit 
pack, see “PR-MEM.”
Notes:
a. Non-TN790 is on the processor circuit pack and not on a separate 
memory circuit pack. The maintenance object is "MEMORY" and not 
"MEM-BD." However, all references to MEM-BD in this section are 
applicable to "MEMORY" as well.
The Memory contains the DEFINITY software and firmware. The Processor 
circuit pack is the most critical component of all system operations.
b. Non-TN790 systems contain memory that is integrated with the processor. 
For testing purposes, the circuit pack is logically separated into 
PR-MAINT, PROCR, and MEMORY. This means that a memory problem on 
386 systems requires that the Processor be replaced. 386 systems 
contain two types of memory: Flash ROM and DRAM. Flash ROM is 
permanent memory that contains the boot image, PI firmware, and 
PACCON firmware. This type of memory is not erased during circuit pack 
resets. It can be reprogrammed only via the 
upgrade software
 command. 
DRAM is used for software data storage, and it changes constantly. 
DRAM loses its value during circuit pack resets. Both types of memory are 
present on the Processor circuit pack. The diagnostics run appropriate 
tests on both memories.
For all system activity, the Processor must be able to access the Memory. 
If the Processor cannot do this, the system goes into SPE-down mode. In 
SPE-down mode, fatal Memory errors may show up as Processor errors. 
This merely indicates that the Processor and the Memory are very closely 
linked as a matter of course.
If the initialization diagnostics fail, refer to the "Procedure for SPE-Down 
Mode" section in 
Memory faults usually indict the Processor circuit pack (TN790) or the 
CPP1 circuit pack, however the problem may be on the TN786B.
MO Name (in 
Alarm Log)
Alarm Level
Initial Command to Run
Full Name of MO
MEM-BD
MAJOR
test memory l c
Memory
MEM-BD (a)
WARNING
test memory sh c
Memory
MEMORY (b)
MAJOR
test memory a/b sh c
Memory