Lucent Technologies R5SI 用户手册
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1008
PDMODULE, TDMODULE (Data Module)
10
NPE Crosstalk Test (#9)
One or more NPEs reside on each circuit pack with a TDM Bus interface. The
NPE controls port connectivity and gain, and provides conferencing functions on
a per-port basis. The NPE Crosstalk Test verifies that this port’s NPE channel
talks on the selected time slot and never crosses over to time slots reserved for
other connections. If the NPE is not working correctly, one-way and noisy
connections may be observed. If a secondary data module is assigned, it is
tested after the primary data module. If either test fails, both data modules are
taken out of service This test usually runs only during the Long Test Sequence
and takes about 20 to 30 seconds to complete.
NPE controls port connectivity and gain, and provides conferencing functions on
a per-port basis. The NPE Crosstalk Test verifies that this port’s NPE channel
talks on the selected time slot and never crosses over to time slots reserved for
other connections. If the NPE is not working correctly, one-way and noisy
connections may be observed. If a secondary data module is assigned, it is
tested after the primary data module. If either test fails, both data modules are
taken out of service This test usually runs only during the Long Test Sequence
and takes about 20 to 30 seconds to complete.
Table 10-289.
TEST #9 NPE Crosstalk Test
Error
Code
Test
Result
Description/ Recommendation
1
ABORT
During testing of the primary information channel,
system resources may not have been available.
system resources may not have been available.
1. Check the port status. Use the
display port
PCSSpp
command to determine the station
extension of the port. Use the
station status
command to determine the service state of the port.
If the service state indicates that the port is in use,
then the port is unavailable for this test. You must
wait until the port is idle.
If the service state indicates that the port is in use,
then the port is unavailable for this test. You must
wait until the port is idle.
2. If the port status is idle, then retry the command at
one-minute intervals a maximum of five times.
3. If the test continues to abort, escalate the problem.
1000
ABORT
System resources required to run this test are not
available. The port may be busy with a valid call. Use
the
available. The port may be busy with a valid call. Use
the
display port PCSSpp
command to determine the
extension of the data module port. Use the
status
data-module
command to determine the service state
of the port. If the service state indicates that the port is in
use, then the port is unavailable for certain tests. (Refer
to the "Status Commands" section in
use, then the port is unavailable for certain tests. (Refer
to the "Status Commands" section in
for a full description of all possible states). You must wait
until the port is idle before retesting.
until the port is idle before retesting.
1. If the port status is idle, retry the command at
one-minute intervals a maximum of five times.
2. If the test continues to abort, escalate the problem.
Continued on next page