Lucent Technologies R5SI 用户手册

下载
页码 2643
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si  
555-230-123  
Issue 1
April 1997
Maintenance Object Repair Procedures 
Page 10-1425
TIE-DS1 (DS1 Tie Trunk) 
10
TIE-DS1 (DS1 Tie Trunk)
The DS1 tie trunk provides both voice and data inter-PBX communication. A 24 
channel DS1 Interface circuit pack can support up to 24 digital tie trunks through 
a 1.544 Mbps DS1 link. A 32 channel DS1 Interface circuit pack can support up 
to 30 digital tie trunks through a 2.048 Mbps DS1 link. DS1 Interface circuit packs 
are described in DS1-BD. DS1 Tie Trunks are used widely in the DCS and 
Central Attendant Service (CAS) features of the system.
A DS1 tie trunk can also be used as an access endpoint which is a non-signaling 
channel with a bandwidth of voice-grade-data, 56K-data or 64K-data.
DS1 tie trunk maintenance provides a strategy to maintain a DS1 tie trunk via a 
port on the DS1 Interface circuit pack. The maintenance strategy covers logging 
DS1 tie trunk hardware errors, running tests for trunk initialization, periodic and 
scheduled maintenance, system technician-demanded tests, and alarm 
escalation and resolution. Three different trunk service states are specified in the 
DS1 tie trunk maintenance. They are: 
out-of-service
 in which the trunk is in a 
deactivated state and cannot be used for either incoming or outgoing calls; 
in-service
 in which the trunk is in an activated state and can be used for both 
incoming and outgoing calls; 
disconnect
 (ready-for-service) in which the trunk is 
in an activated state but can only be used for an incoming call. If the DS1 
Interface circuit pack is out-of-service, all trunks on the DS1 Interface circuit pack 
are placed into out-of-service state, and a Warning alarm is raised.
1.
For additional repair information, see also DS1-BD (DS1 Interface Circuit Pack) 
Maintenance documentation.
2.
A MAJOR alarm on a trunk indicates that alarms on these trunks are not downgraded 
by the 
set options
 command and that at least 75 percent of the trunks in this trunk 
group are alarmed.
MO Name As 
It Appears in 
Alarm Log
Alarm 
Level
Initial System 
Technician Command 
to Run
Full Name of MO
TIE-DS1
1
MAJOR
2
test trunk <grp/mbr> l
DS1 Tie Trunk
TIE-DS1
MINOR
test trunk <grp/mbr> l
DS1 Tie Trunk
TIE-DS1
WARNING
test trunk <grp/mbr>
DS1 Tie Trunk