Lucent Technologies R5SI 用户手册
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-144
display system-parameters maintenance
8
Scheduled Maintenance
A series of maintenance tests and operations runs automatically every day
according to the schedule and settings specified in the following fields.
according to the schedule and settings specified in the following fields.
Packet Bus Activated
Enables the system Packet Bus.
If this field is set to ‘‘yes'', then maintenance software assumes
that there is a Packet Control circuit pack installed in the
system. The packet endpoints (for example, ASAI, and/or BRI)
may be administered, and maintenance testing runs on both
the Packet Control circuit pack and on the Packet Bus (This
field should be set to “yes” after a packet control circuit pack is
installed.). If a Packet Control circuit pack is not installed in the
system, then a major alarm is raised against the PKT-CTRL MO.
This field can only be changed from ‘‘yes'' to ‘‘no'' if there are
no packet endpoints administered, thus ensuring that there
can be no packet endpoints administered if the packet bus is
not activated.
If this field is set to ‘‘yes'', then maintenance software assumes
that there is a Packet Control circuit pack installed in the
system. The packet endpoints (for example, ASAI, and/or BRI)
may be administered, and maintenance testing runs on both
the Packet Control circuit pack and on the Packet Bus (This
field should be set to “yes” after a packet control circuit pack is
installed.). If a Packet Control circuit pack is not installed in the
system, then a major alarm is raised against the PKT-CTRL MO.
This field can only be changed from ‘‘yes'' to ‘‘no'' if there are
no packet endpoints administered, thus ensuring that there
can be no packet endpoints administered if the packet bus is
not activated.
This field should be set to “yes” after a Packet Control circuit
pack is installed.
If a Packet Control circuit pack is not installed, then this field
should be set to ‘‘no'' (the only exception is when setting up
translations for a system for which not all of the required
hardware is available). (no)
pack is installed.
If a Packet Control circuit pack is not installed, then this field
should be set to ‘‘no'' (the only exception is when setting up
translations for a system for which not all of the required
hardware is available). (no)
Customer Access to
INADS Port
INADS Port
Provides the capability to prohibit access to system
administration and maintenance interface, via the INADS port
when using customer login ID’s. This field can only be activated
by Lucent services through system-parameters maintenance
administration.(no)
administration and maintenance interface, via the INADS port
when using customer login ID’s. This field can only be activated
by Lucent services through system-parameters maintenance
administration.(no)
Repeat Dial Interval
(MMS)
(MMS)
Indicates the number of minutes that the system must wait
before attempting another call origination to an OSS. This timer
is triggered by the lack of a far-end acknowledgment. (7)
before attempting another call origination to an OSS. This timer
is triggered by the lack of a far-end acknowledgment. (7)
Start Time
The hour and minute in 24-hour notation at which daily scheduled
maintenance will begin running. (22:00)
maintenance will begin running. (22:00)
Stop Time
The hour and minute when scheduled daily maintenance will stop
running. If any daily maintenance operations are not completed by
this time, the system will note where in the sequence it stopped and
perform those operations during the next scheduled daily
maintenance.
running. If any daily maintenance operations are not completed by
this time, the system will note where in the sequence it stopped and
perform those operations during the next scheduled daily
maintenance.
Daily
Maintenance
Maintenance
This display-only field simply represents the series of tests that are
always run by maintenance software as part of daily maintenance.
always run by maintenance software as part of daily maintenance.