Lucent Technologies R5SI 用户手册

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-557

test card-mem 

For a duplex switch configuration, the following message will be displayed:

Enter [cabinet(1)];carrier(A-B), [’long’ or ’short’],

[’repeat’ (1-100) or ’clear’], [’schedule’]

If the SPE is not active, the following message will be displayed:

Command must be executed from active SPE

If the carrier entered is invalid, the following message will be displayed:

"entered value" is an invalid identifier;

press RETURN to execute modified command

If the NETCON board is not TN777B, the following message is displayed:

Must install TN777B circuit pack

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

If the standby is entering maintenance mode when this command is executed, 
then the following message is displayed:

Cannot interrupt Standby SPE while entering

maintenance mode; please try later

If the standby SPE is not refreshed when this command is executed, then the 
following message is displayed:

Standby SPE memory not refreshed;

use the "refresh spe-standby" command.

If the standby SPE is not refreshed and the active SPE is hard selected via the 
SPE select switches when this command is executed, then the following 
message is displayed:

Active SPE locked via select switches;

Standby SPE memory not refreshed

If the standby SPE is busy with another task, then the following message is 
displayed

Standby SPE busy with another task;

for information use "status system 1"

If the standby SPE is not available when this command is executed, then the 
following message is displayed:

Standby SPE not available;

for information use "status system 1"