Lucent Technologies R5SI 用户手册

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-575

test duplication-interface 

Cannot interrupt Standby SPE while entering

maintenance mode; please try later

If the standby SPE is not refreshed when this command is executed, then the 
following message is displayed:

Standby SPE memory not refreshed; 

use the "refresh spe-standby" command.

If the standby SPE is not refreshed and the active SPE is hard selected via the 
SPE select switches when this command is executed, then the following 
message is displayed:

Active SPE locked via select switches;

Standby SPE memory not refreshed

If the standby SPE is busy with another task, then the following message is 
displayed:

Standby SPE busy with another task;

for information use "status system 1"

If the standby SPE is not available when this command is executed, then the 
following message is displayed:

Standby SPE not available;

for information use "status system 1"

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

The responses will be displayed on a test-by-test basis with one line of data 
displayed for each test result.

Port

The port address (cabinet-carrier) will always be 01A or 01B.

Maintenance Name

The maintenance name will always be SHDW-CIR, SPE-SELE, or 
DUPINT.

Alt. Name

Not applicable.

Test No.

The actual test that is being executed.

Result

The result of the individual test -"PASS," "ABORT," "FAIL," "NO 
BOARD," "DISABLED."

Error Code

A system-generated number that tells why the test failed or 
aborted. A detailed list of the codes according to "Test No." is 
provided for each MO.