Lucent Technologies R5SI 用户手册

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-680

test trunk 

If a software fault is encountered while the command is executing, the following 
message will be displayed:

Error encountered, can’t complete request

If the trunk group is not administered, the following message will be displayed:

Group not assigned, or group assigned but with no member

If the trunk group member is not administered, the following message will be 
displayed:

Group member not assigned

If there are no tests found for this maintenance object, the following message will 
be displayed:

No tests for this MO

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

Command resources busy; 

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

All maintenance resources busy; try again later

The responses will be displayed on a test-by-test basis with one line of data 
displayed for each test result.

Port

The port address (cabinet-carrier-slot-circuit) of the maintenance 
object that is being tested.

Maintenance Name

The type of maintenance object that is being tested.

Alt. Name

The alternate means of identifying the maintenance object. This 
field contains xxx/yyy when the object is a trunk, where xxx is the 
trunk group number and yyy is the member number. It contains 
P/xxx when the object is a private CO line, where xxx is the private 
CO line group number.