Emerson MVME7100 用户手册
MVME7100 Single Board Computer Installation and Use (6806800E08A)
Hardware Preparation and Installation
Installing Accessories
40
If you are installing the optional MVME7216E transition module, refer to
Transition Module
on
page 40
for configuration switch settings.
2.5
Installing Accessories
This section describes the procedures for installing the MVME7216E transition module, PMCs,
and the XMCspan on the baseboard.
and the XMCspan on the baseboard.
2.5.1
Transition Module
The MVME7216E does not support hot swap, You should remove power to the rear slot or
system before installing the module. Before installing the MVME7216E transition module, you
may need to manually configure the switch and install a PMC I/O Module (PIM). Refer to
system before installing the module. Before installing the MVME7216E transition module, you
may need to manually configure the switch and install a PMC I/O Module (PIM). Refer to
Chapter 5, Transition Module
, for switch settings and PIM installation.
S2-8
GA0
1
1. The VME SCON MAN switch is OFF to select Auto-SCON mode. The switch is ON to select manual SCON mode
which works in conjunction with the VME SCON SEL switch.
which works in conjunction with the VME SCON SEL switch.
2. The VME SCON SEL switch is OFF to select non-SCON mode. The switch is ON to select always SCON mode.
This switch is only effective when the VME SCON MAN switch is ON.
This switch is only effective when the VME SCON MAN switch is ON.
Table 2-6 VME System Controller and GA Switch Settings (continued)
Position
Function
Default
Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or
shorten their life.
Before touching the board or electronic components, make sure that you are working
in an ESD-safe environment.
Electrostatic discharge and incorrect installation and removal can damage circuits or
shorten their life.
Before touching the board or electronic components, make sure that you are working
in an ESD-safe environment.
Product Damage
Only use injector handles for board insertion to avoid damage to the front panel
and/or PCB. Deformation of the front panel can cause an electrical short or other
board malfunction.
Only use injector handles for board insertion to avoid damage to the front panel
and/or PCB. Deformation of the front panel can cause an electrical short or other
board malfunction.
Board Malfunction
Switches marked as “reserved” might carry production-related functions and can
cause the board to malfunction if their setting is changed.
Do not change settings of switches marked as “reserved”. The setting of switches
which are not marked as “reserved” has to be checked and changed before board
installation.
Switches marked as “reserved” might carry production-related functions and can
cause the board to malfunction if their setting is changed.
Do not change settings of switches marked as “reserved”. The setting of switches
which are not marked as “reserved” has to be checked and changed before board
installation.