Omron C200HX 用户手册
486
Response Format
@
K
S
x 10
0
x 10
1
x 16
1
x 16
0
↵
Node no.
Header
code
code
Terminator
FCS
End code
Limitations
Bits in SR 253 through SR 255 can’t be specified.
PC Settings
PC Mode
UM Area
RUN
MONITOR
PROGRAM
Write-protected
Read-protected
---
OK
OK
OK
OK
Execution Conditions
Commands
Responses
Single
Multiple
Single
Multiple
OK
---
OK
---
End Codes
An end code of 14 (format error) will be returned if the length of the command is
incorrect.
incorrect.
An end code of 15 (entry number data error) will be returned if the operand, word
address, or bit parameter setting is incorrect.
address, or bit parameter setting is incorrect.
End code
Contents
00
Normal completion
01
Not executable in RUN mode
13
FCS error
14
Format error
15
Entry number data error
18
Frame length error
10-3-27
FORCED RESET –– KR
Force resets an IR, SR, LR, HR, or AR bit or the Completion Flag of a timer or
counter. Once a bit has been forced set or reset, that status will be retained until
FORCED SET/RESET CANCEL (KC) is transmitted.
counter. Once a bit has been forced set or reset, that status will be retained until
FORCED SET/RESET CANCEL (KC) is transmitted.
Command Format
@
K
R
x 10
0
x 10
1
x 10
3
x 10
2
x 10
1
x 10
0
x 10
1
x 10
0
↵
OP1 OP2 OP3
OP4
Node no.
Header
code
code
Terminator
FCS
Operand
Word
address
address
Bit
For data areas IR, SR, LR, HR, and AR, the “Operand” parameter indicates the
data area where the bit will be force-set and the “Word address” parameter indi-
cates the word address.
data area where the bit will be force-set and the “Word address” parameter indi-
cates the word address.
Host Link Commands
Section 10-3