ASUS P5Q-VM 用户手册

ASUS P5Q-VM

1-43

1.  After making all the connections, replace the system case cover. 
2.  Be sure that all switches are off.
3.  Connect the power cord to the power connector at the back of the system 

chassis.

4.  Connect the power cord to a power outlet that is equipped with a surge 

protector.

5.  Turn on the devices in the following order:
 

a.  Monitor

 

b.  External SCSI devices (starting with the last device on the chain)

 

c.  System power

6.  After applying power, the system power LED on the system front panel case 

lights up. For systems with ATX power supplies, the system LED lights up 

when you press the ATX power button. If your monitor complies with “green” 

standards or if it has a “power standby” feature, the monitor LED may light up 

or switch between orange and green after the system LED turns on.

 

The system then runs the power-on self tests or POST. While the tests are 

running, the BIOS beeps (see BIOS beep codes table below) or additional 

messages appear on the screen. If you do not see anything within 30 

seconds from the time you turned on the power, the system may have failed 

a power-on test. Check the jumper settings and connections or call your 

retailer for assistance.

7.  At power on, hold down the <Delete> key to enter the BIOS Setup. Follow the 

instructions in Chapter 2.

One short beep

VGA detected 

Quick boot set to disabled 

No keyboard detected 

One continuous beep followed by two 

short beeps then a pause (repeated)

No memory detected

One continuous beep followed by three 

short beeps

No VGA detected

One continuous beep followed by four 

short beeps

Hardware component failure