Advantech PCM-3350 Series 用户手册

PCM-3350  User's Manual

this in the system BIOS setup. The table below shows the settings for
the PCA-3350F Series' board's ports:

Table 2-3: Serial port default settings

COM1

3F8, 3E8

IRQ4

3F8

COM2

2F8, 2E8

IRQ3

2F8

The built-in Enhanced IDE (Integrated Device Electronics) controller
supports up to two IDE devices, including CD-ROM drives, tape
backup drives, a large hard disk drive and other IDE devices.

Connecting drives is done in a daisy-chain fashion. It requires one or
two cables, depending on the drive size. 

IDE 1.8" and 2.5" drives need a 1 x 44-pin to 2 x 44-pin flat-cable
connector

  (included).   IDE 3.5" drives need a 1 x 44-pin to 2 x 40-pin

connector

  (not included).

Wire number 1 on the cable is red or blue, and the other wires are gray.

1. Connect one end of the cable to CN5. Make sure that the red (or

blue) wire corresponds to pin 1 on the connector, which is labeled
on the board (on the right side).

2. Plug the other end of the cable into the Enhanced IDE hard drive,

with pin 1 on the cable corresponding to pin 1 on the hard drive.
Unlike floppy drives, IDE hard drives can connect to either end of
the cable. If you install two drives, you will need to set one as the
master and one as the slave by using jumpers on the drives. If you
install just one drive, set it as the master.

Refer to Appendix B in this manual.