AMD SB750 用户手册

 

 
                                                                                                                                                                                                                                                                                                                                                             

 
 
 

WARNING!  Turn off your power when adding or removing expansion cards or other 

system components.    Failure to do so may cause severe damage to both 
your motherboard and expansion cards.   

Before using your computer, you had better complete the following steps: 
1.  Check motherboard jumper setting 
2.  Install CPU and Fan 
3.  Install System Memory (DIMM) 
4.  Install Expansion cards 
5.  Connect IDE and Front Panel /Back Panel cable 
6.  Connect ATX Power cable 
7.  Power-On and Load Standard Default 
8.  Reboot 
9.  Install Operating System   
10.  Install Driver and Utility 

A battery must be used to retain the motherboard configuration in CMOS RAM short 1-2 
pins of JBAT to store the CMOS data. 

To clear the CMOS, follow the procedure below: 
1. 

Turn off the system and unplug the AC power 

2. 

Remove ATX power cable from ATX power connector 

3. 

Locate JBAT and short pins 2-3 for a few seconds 

4. 

Return JBAT to its normal setting by shorting pins 1-2 

5. 

Connect ATX power cable back to ATX power connector 

 

1-2 Closed KB/USB Power ON Disable (Default)