Ampro Corporation 420 用户手册

12

QuickStart Guide

CoreModule 420

3. Remove the DiskOnChip from the anti-static package and check it for bent pins, before

attempting to insert it into the bytewide socket (U5).

4. Align pin one of the bytewide socket (U5) with pin 1 of the DiskOnChip.  See Figure 2-1.

5. Gently insert the DiskOnChip into the bytewide socket (U5) as shown in Figure 2-1 and gently

rock it side to side, while pressing down, until it is firmly into the bytewide socket (U5).

6. Set the jumpers for JP4, JP5, and JP7 to boot from the DiskOnChip before you restore power to

the CoreModule 420.  See Table 2-1

Enable BIOS – Normal operation;
boots from flash (Pins 1-3)

Disabled (See other positions)

Enable External BIOS – Used for
recovery (Pins 1-2)

Disabled (See other positions)

JP4  & JP5
BIOS Select

Enable DOC – Boot from
DiskOnChip in bytewide socket
(Pins 1-3 & 2-4) Default

Disabled (See other positions)

JP7     DiskOnChip
           Boot Address

Boot from DC000h-DDFFFh
(Pins 1-2)

Boot from CC000h- CDFFFh
(No jumper)

Refer to the CoreModule 420 Reference Manual for more information on
the location of the jumpers, as well as, other jumper settings.  Refer also
to Table 1-1 in this manual.