Analog Devices ADSP-21535 E-KIT LITE 用户手册
3. Plug the provided power supply into P10 on the EZ-KIT Lite board.
Visually verify that the green power LED (LED6) is on. Also verify that
the two red reset LEDs (LED7 and LED8) go on for a moment and then
go off.
the two red reset LEDs (LED7 and LED8) go on for a moment and then
go off.
4. Connect the USB cable to an available full speed USB Port and to P7 on
the ADSP-21535 EZ-KIT Lite board.
2.4.5 Installing the EZ-KIT Lite USB Driver
The EZ-KIT Lite evaluation system can be installed on Windows 98 and
Windows 2000 and requires one full-speed USB port. Section
Windows 2000 and requires one full-speed USB port. Section
the installation on Windows 98. Section
Windows 2000.
2.4.5.1 Windows 98 USB Driver Installation
Before using the ADSP-21535 EZ-KIT Lite for the first time, the Windows 98
USB driver must first be installed.
USB driver must first be installed.
To install the USB driver:
1. Insert the EZ-KIT Lite CD-ROM into the CD-ROM drive.
The connection of the device to the USB port will activate the Windows 98 “Add
New Hardware Wizard” as shown in
The connection of the device to the USB port will activate the Windows 98 “Add
New Hardware Wizard” as shown in
Figure 2-2: Add New Hardware Wizard Dialog Box
ADSP-21535 EZ-KIT Lite Evaluation System Manual
2-5