DCS dCS Verona Master Clock 用户手册

下载
页码 45
dCS Verona User Manual
Manual for Software Issue 1.0x
dCS Ltd
September 2004
Manual filename: Verona Manual v1.0x.doc
Page 23
email: more@dcsltd.co.uk
English version
web-site: www.dcsltd.co.uk
1394
 Interface
The 1394 interface in not fitted in this release. It is intended for future
enhancements.
Power Link
This can be linked to similar connectors on other dCS units using a link cable.
All units linked in this way may be turned on or off or set to standby by pressing
a single 
Power
 button or sending one Remote Control command. Link cables
are available from dCS.
SUC
The Software
 
Upgrade Connector is intended to be used by dCS service agents
to load new software into Verona.
IMPORTANT! 
Do not connect any other equipment to the SUC connector as this may
damage both Verona and the equipment so connected. Do not operate
Verona with a PC connected. Failure to observe this warning will void the
unit’s warranty, and may cause unpleasant effects in your system.
Power switch
The Power switch completely isolates the unit from the power supply. In normal
use, set it to the On position (
I
). Set it to Off (
0
) during electrical storms, or while
you are away for a long period.
IEC Power Inlet
Use with a 3 - pin IEC type power cable.
Mains Fuse
Replace only with a 20 x 5mm 500mA T HRC fuse. Please see page
  32
replacement details.
Additional Information
The rear panel displays the following information about the unit:
 
The manufacturer’s name and address.
 
Supply voltage setting, frequency range and rated power.
 Model: 
 
dCS Verona
 
The short form of the unit serial number.
We will need the serial number (preferably the full serial number from the menu)
to give you support over the phone, or to ship you software updates.