Toshiba EO1-11113 用户手册
– 38 –
EO1-11113
STORE NAME/MESSAGE AND COMMERCIAL MESSAGE
PROGRAMMING (Submode 1)
PROGRAMMING (Submode 1)
Any time outside a sale
Mode Lock: SET
NOTES:
1. For each line, a maximum of 24 regular-size characters or 12 double-sized characters
may be entered. A combination of both types is also available.
2. Even if the option “Store Name Print by RUBBER STAMP” is selected, data can be
programmed for the store name/message. However, the Rubber Stamp, instead of the
programmed name/message will actually be printed for operations to issue receipts.
programmed name/message will actually be printed for operations to issue receipts.
If the option “Store Name Print by DOT PRINTER” is selected, use 1 through 4 for the store
name/message and 5 through 7 for the commercial message data, as Line No.
name/message and 5 through 7 for the commercial message data, as Line No.
The range Line Nos. 5 to 7 is unavailable to a manual-cut printer.
3. If no commercial message is required on the receipt, program blanks for all three lines.
As a result no extra lines will be fed. If any one of the three lines is programmed, the two
other lines will cause line feeds.
other lines will cause line feeds.
4. The 4-line range assigned for the store name/message will be either printed or fed,
regardless of any system option selection.
5. If any incorrect characters have been programmed, depress the [C] key to clear all the
characters on a line and then re-enter characters from the beginning, or end the line with
an [ST] and re-program the entire line. The new data will be active.
an [ST] and re-program the entire line. The new data will be active.
6. When all the lines have been programmed, do a check by issuing receipt. Only the lines
with errors need to be re-programmed; other lines will not be affected.
....
To complete this line
Repeat for another line.
| Line No. | [ST]
(For sequentially
programming lines, the line
number specification can be
skipped.)
programming lines, the line
number specification can be
skipped.)
[AT/TL]
[ST]
1 [X]
Submode No.
Character Entries
max. 24 characters/line
(See CHARACTER ENTRIES
at the beginning of this
chapter.)
at the beginning of this
chapter.)
....
1 to 4:
or
5 to 7:
or
5 to 7:
....
OPERATION
CONDITION
(See NOTE 2
below.)
below.)
....
To complete this
programming
operation
programming
operation