Toshiba EO1-11113 用户手册

– 50 –

EO1-11113

This operation is used to copy the programmed data of a PLU item and to use it in programming an-
other PLU item, thus eliminating time in PLU programming operation.

To program new PLUs or to change any programmed contents of PLUs:

Any time outside a sale (except the following case)

To change the PLU of the copy-destination with sales data not zero:

After PLU Reset

Mode Lock: SET

ex.)

To program PLU 90701 (7-up Small-B) again that was once
programmed and then deleted, by copying the programmed data
of PLU 90601 (Coke Small-B):

Mode Lock: SET, enter 4, depress [X]

90701 [PLU] (PLU Code of the copy-destination)
[NS]
90601 [PLU] (PLU Code of the copy-source)
2 [ST]

7-up Small-B [ST]
(Address 2, Name changed into: 7-up Small-B)

9 [ST] 7 [#]

(Address 9, PLU Group No. changed into : 7)

[AT/TL] (to end this submode)

4 [X]

| PLU Code of the copy-destination |

| PLU Code of the copy-source |

The programmed data of the copy-source PLU is now copied
to the copy-destination PLU (except the PLU Code).  Then
follow the procedure on the page of Programming or
Changing to change data of any required Addresses.

1343 PEACH DRIVE

PHONE : 87-6437

Open 8:00am to 7:00pm

Closed : every Wednesday

11-14-1994  MON  #1

OPERATION

CONDITION