Q-Logic 8100 SERIES 用户手册
8–Configuring FCoE in a Linux Environment
Boot-from-SAN
FE0254601-00 A
8-35
Configuring an Adapter to Boot-from-SAN
This section describes how to configure a QLogic 8100 Series Adapter to boot the
RHEL 5 operating system from the SAN.
RHEL 5 operating system from the SAN.
1.
Install the QLogic 8100 Series Adapter, and update the firmware, if
necessary. For information about updating the firmware, refer to
necessary. For information about updating the firmware, refer to
2.
Connect the SAN components in a single-path topology as shown in
If a multipath topology is required, make the necessary
additions and connections after the initial operating system installation.
3.
Power up the server.
If this is a BIOS server, press CTRL+Q or ALT+Q while the server is
booting, to open the QLogic Fast!Util BIOS configuration utility.
Proceed to
booting, to open the QLogic Fast!Util BIOS configuration utility.
Proceed to
.
If this is a UEFI server, select EFI Shell from the EFI Boot Manager
menu while the server is booting. Proceed to
menu while the server is booting. Proceed to
4.
Configure the BIOS server. For information about configuring an UEFI
server, proceed to
server, proceed to
a.
Configure the switch with a zone that includes the adapter port and
one storage array port, using either soft zoning (WWPN-based) or hard
zoning (port number-based), and enable the zone. Soft zoning is
recommended because, if a server malfunctions, you can move the
adapter to another host without reconfiguration.
one storage array port, using either soft zoning (WWPN-based) or hard
zoning (port number-based), and enable the zone. Soft zoning is
recommended because, if a server malfunctions, you can move the
adapter to another host without reconfiguration.
b.
Create an appropriately-sized LUN on the storage array. The LUN size
depends on the operating system to be installed. Add this LUN to a
host group containing the QLogic adapter.
depends on the operating system to be installed. Add this LUN to a
host group containing the QLogic adapter.
c.
Set the host type/mode for the host group that corresponds to the
operating system to be installed. The boot LUN should be LUN 0. For
information about using a LUN other than LUN 0, refer to
operating system to be installed. The boot LUN should be LUN 0. For
information about using a LUN other than LUN 0, refer to
.
d.
In the QLogic Fast!UTIL BIOS configuration utility on the server, select
the adapter port in the Select Host Adapter menu, and then press
ENTER.
the adapter port in the Select Host Adapter menu, and then press
ENTER.
e.
Select Configuration Settings from the Fast!UTIL Options menu, and
press ENTER.
press ENTER.
f.
Select Adapter Settings from the Configuration Settings menu, and
then press ENTER.
then press ENTER.
g.
Change Host Adapter BIOS to Enabled in the Adapter Settings menu,
and press ENTER.
and press ENTER.