Q-Logic 8100 SERIES 用户手册
3–Installation in a Windows Environment
Installing Software
FE0254601-00 A
3-27
7.
Windows presents a list of mass storage device drivers to load in addition to
the standard drivers that have already been installed (
the standard drivers that have already been installed (
required, specify other devices, or press ENTER to continue with the
installation.
installation.
Figure 3-36. Install Additional Drivers
8.
Continue with the standard Windows Server 2003 installation procedure. For
more information about the other QLogic BIOS configurations required to
enable a server to boot from SAN, refer to
more information about the other QLogic BIOS configurations required to
enable a server to boot from SAN, refer to
.
Initial Windows Server 2008 Installation with the Converged Network Adapter as
Boot Device (for FCoE Driver Only)
To initially install Windows Server 2008 on the boot‐from‐SAN disk attached to the QLogic
Converged Network Adapter:
Converged Network Adapter:
1.
Start the Windows installation procedure using the setup CD.
2.
Read and accept the Windows End User License Agreement.