Shure BLD5760 用户手册
GE Protimeter Aquant
Page 3
2. Scroll across the display and record the following information:
a.
part number
(
“bLd5760”
)
b.
firmware date in the form yy-mm-dd (e.g
.
“04-05-20”
)
c.
calibration code (e.g.
E1-1
)
.
Note:
Once the scrolling is complete, display shows
“0 = 0” meaning that option 0 is set to 0. The
and buttons may now be used to change the instrument options and settings,
respectively, as detailed in Table 1 below.
Note:
The instrument options can only be changed in numerical order (0, 1, and 2 respectively).
Save setting changes and exit the Set-up mode by pressing
Save setting changes and exit the Set-up mode by pressing
again, as in Step 4 of the
following example:
Example:
To switch the audible beeper
OFF
and set the auto switch
OFF
time to 3 minutes, complete the
following steps:
1. Press and hold followed by
to enter Set-up mode.
2. When display shows 0 = 0, press
once to select beeper options (1), then press until the
display shows
1 = 0.
TABLE 1. User Set-Up Options
When
Option No. Is:
And Setting
Number Is:
Aquant Set-Up Is:
0
0
Instruments settings are not changed from previous settings
1
Instrument default settings loaded - switches
OFF
automatically after 1 minute, beeper is activated, factory-set
zeroing
zeroing
1
0
Beeper is switched
OFF
1
Beeper beeps when switching from one mode to the other
2
Beeper beeps with increasing frequency from nominal value
of 170
2
0
Auto switch
OFF is not active. Instrument can only be
switched
OFF by pressing
and holding it for over 3 sec.
1
Auto switch
OFF is active. Instrument switches OFF after 1
minutes
2
Auto switch
OFF is active. Instrument switches OFF after 2
minutes
3
Auto switch
OFF is active. Instrument switches OFF after 3
minutes