Baldor Baldor 用户手册
Appendix A
CE Guidelines
CE Guidelines
Appendix A-1
MN850
CE Declaration of Conformity
Baldor indicates that the products are only components and not ready for immediate or instant use
within the meaning of “Safety law of appliance”, “EMC Law” or “Machine directive”.
The final mode of operation is defined only after installation into the user’s equipment. It is the
responsibility of the user to verify compliance.
The product conforms with the following standards:
EN 60947–4–2
within the meaning of “Safety law of appliance”, “EMC Law” or “Machine directive”.
The final mode of operation is defined only after installation into the user’s equipment. It is the
responsibility of the user to verify compliance.
The product conforms with the following standards:
EN 60947–4–2
Low–voltage switch gear and control gear – Contactors and motor
starters – AC semiconductor motor controllers and starters.
starters – AC semiconductor motor controllers and starters.
EMC – Conformity and CE – Marking
The information contained herein is for your guidance only and does not guarantee that the
installation will meet the requirements of the council directive 89/336/EEC.
The purpose of the EEC directives is to state a minimum technical requirement common to all the
member states within the European Union. In turn, these minimum technical requirements are
intended to enhance the levels of safety both directly and indirectly.
Council directive 89/336/EEC relating to Electro Magnetic Compliance (EMC) indicates that it is the
responsibility of the system integrator to ensure that the entire system complies with all relative
directives at the time of installing into service.
Motors and controls are used as components of a system, per the EMC directive. Hence all
components, installation of the components, interconnection between components, and shielding and
grounding of the system as a whole determines EMC compliance.
The CE mark does not inform the purchaser which directive the product complies with. It rests upon
the manufacturer or his authorized representative to ensure the item in question complies fully with all
the relative directives in force at the time of installing into service, in the same way as the system
integrator previously mentioned. Remember, it is the instructions of installation and use, coupled with
the product, that comply with the directive.
installation will meet the requirements of the council directive 89/336/EEC.
The purpose of the EEC directives is to state a minimum technical requirement common to all the
member states within the European Union. In turn, these minimum technical requirements are
intended to enhance the levels of safety both directly and indirectly.
Council directive 89/336/EEC relating to Electro Magnetic Compliance (EMC) indicates that it is the
responsibility of the system integrator to ensure that the entire system complies with all relative
directives at the time of installing into service.
Motors and controls are used as components of a system, per the EMC directive. Hence all
components, installation of the components, interconnection between components, and shielding and
grounding of the system as a whole determines EMC compliance.
The CE mark does not inform the purchaser which directive the product complies with. It rests upon
the manufacturer or his authorized representative to ensure the item in question complies fully with all
the relative directives in force at the time of installing into service, in the same way as the system
integrator previously mentioned. Remember, it is the instructions of installation and use, coupled with
the product, that comply with the directive.
Wiring of Shielded (Screened) Cables
Conductive
Clamp
Clamp
Remove the outer insulation
to expose the overall screen.
to expose the overall screen.