Multitech 810-SS MVP210 用户手册
Chapter 1 – Product Overview
MultiVOIP® Voice/Fax over IP Gateways
7
Interfaces to Help You Use the MultiVOIP
Two interfaces help you use your MultiVOIP:
●
A web interface
●
Windows software interface
The web interface and the Windows interface share content and organizational attributes. However, each
interface has different logging capabilities.
interface has different logging capabilities.
Overview of Front Panel LEDs
Eight sets of channel‐operation LEDs appear on both the MVP410 and MVP810 models. However, on the
MVP410, only the lower four sets of channel‐operation LEDs are functional. On the MVP810, all eight sets are
functional.
MVP410, only the lower four sets of channel‐operation LEDs are functional. On the MVP810, all eight sets are
functional.
An illustration of the MVP410/810 LEDs follows.
The MVP210 models have the general‐operation indicator LEDs and two sets of channel‐operation LEDs. An
illustration of the MVP210 LEDs follows.
illustration of the MVP210 LEDs follows.
Front Panel LED Definitions
LED
Description
General Operation LEDs
(one set on each MultiVOIP model)
Power
Indicates presence of power
Boot
After power up, the Boot LED is on briefly while the MultiVOIP is booting. It lights whenever the MultiVOIP is
booting or downloading a setup configuration data set
booting or downloading a setup configuration data set
Ethernet
FDX. LED indicates whether Ethernet connection is half‐duplex or full‐duplex (FDX) and, in half‐duplex mode,
indicates occurrence of data collisions. LED is on constantly for full‐duplex mode; LED is off constantly for half‐
duplex mode. When operating in half‐duplex mode, the LED flashes during data collisions.
indicates occurrence of data collisions. LED is on constantly for full‐duplex mode; LED is off constantly for half‐
duplex mode. When operating in half‐duplex mode, the LED flashes during data collisions.
LNK. Link/Activity LED. This LED is lit if Ethernet connection has been made. It is off when the link is down (that
is, when no Ethernet connection exists). While link is up, this LED flashes off to indicate data activity.
is, when no Ethernet connection exists). While link is up, this LED flashes off to indicate data activity.
Channel‐Operation LEDs (one set for each channel)
XMT
Transmit. This indicator blinks when voice packets are being transmitted to the local area network.
RCV
Receive. This indicator blinks when voice packets are being received from the local area network.
XSG
Transmit Signal. This indicator lights when the FXS‐configured channel is off‐hook, the FXO‐configured channel
is receiving a ring from the Telco, or the M lead is active on the E&M configured channel. That is, it lights when
the MultiVOIP is receiving a ring from the PBX.
is receiving a ring from the Telco, or the M lead is active on the E&M configured channel. That is, it lights when
the MultiVOIP is receiving a ring from the PBX.
RSG
Receive Signal. This indicator lights when the FXS‐configured channel is ringing, the FXO‐configured channel
has taken the line off‐hook, or the E lead is active on the E&M‐configured channel.
has taken the line off‐hook, or the E lead is active on the E&M‐configured channel.