Motorola SBG941 用户手册

1 

SAFETY AND REGULATORY INFORMATION 

IMPORTANT SAFETY INSTRUCTIONS — when using your equipment, basic safety precautions should 
always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 
•  Read all of the instructions listed here and/or in the user manual before you operate this device. Give 

particular attention to all safety precautions. Retain the instructions for future reference. 

•  This device must be installed and used in strict accordance with manufacturer’s instructions, as described 

in the user documentation that is included with the device. 

•  Comply with all warning and caution statements in the instructions. Observe all warning and caution 

symbols that are affixed to this device. 

•  To prevent fire or shock hazard, do not expose this device to rain or moisture. The device must not be 

exposed to dripping or splashing. Do not place objects filled with liquids, such as vases, on the device. 

•  This device was qualified under test conditions that included the use of the supplied cables between 

system components. To ensure regulatory and safety compliance, use only the provided power and 
interface cables and install them properly.  

•  Different types of cord sets may be used for connections to the main supply circuit. Use only a main line 

cord that complies with all applicable device safety requirements of the country of use. 

•  Installation of this device must be in accordance with national wiring codes and conform to local 

regulations. 

•  Operate this device only from the type of power source indicated on the device’s marking label. If you are 

not sure of the type of power supplied to your home, consult your dealer or local power company. 

•  Do not overload outlets or extension cords, as this can result in a risk of fire or electric shock. Overloaded 

AC outlets, extension cords, frayed power cords, damaged or cracked wire insulation, and broken plugs 
are dangerous. They may result in a shock or fire hazard. 

•  Route power supply cords so that they are not likely to be walked on or pinched by items placed upon or 

against them. Pay particular attention to cords where they are attached to plugs and convenience 
receptacles, and examine the point where they exit from the device. 

•  Place this device in a location that is close enough to an electrical outlet to accommodate the length of 

the power cord. 

•  Place the device to allow for easy access when disconnecting the power cord of the device from the AC 

wall outlet. 

•  Do not connect the plug into an extension cord, receptacle, or other outlet unless the plug can be fully 

inserted with no part of the blades exposed. 

•  Place this device on a stable surface. 
•  It is recommended that the customer install an AC surge protector in the AC outlet to which this device is 

connected. This is to avoid damaging the device by local lightning strikes and other electrical surges. 

•  Postpone installation until there is no risk of thunderstorm or lightning activity in the area.  
•  Do not cover the device or block the airflow to the device with any other objects. Keep the device away 

from excessive heat and humidity and keep the device free from vibration and dust. 

•  Wipe the device with a clean, dry cloth. Never use cleaning fluid or similar chemicals. Do not spray 

cleaners directly on the device or use forced air to remove dust. 

•  Do not use this product near water: for example, near a bathtub, washbowl, kitchen sink or laundry tub, in 

a wet basement, or near a swimming pool.