Multitech MT5600ZDX 用户手册

Certain Command Mode configurations are stored in memory registers

called, S-Registers.  The S command is used to assign a value to, and to

read the current value of an S-Register. To assign a value to an S-Register,

enter the letter S, followed by the S-Register number and an equals sign (=).

To read an S-Register value, enter the letter S followed by the S-Register

number and a question mark (?), then hit RETURN. To verify that the S-

Register value was entered correctly, enter for example, ATS8? and hit

RETURN. You should receive a response of the assigned value given to

that S-Register.

rings

0,  1–255 1

Sets the number of rings before

the modem answers. ATS0=0

disables auto-answer complete-

ly.

rings

0–255

0

Counts the number of rings that

have occurred.

decimal 0–255

43 (+)

Sets ASCII code for the escape

character. Values greater than

127 disable the escape sequence.

decimal 0–127

13  (^M) Sets ASCII code for the carriage

return character.

decimal 0–127

10  (^J) Sets ASCII code for the line feed

character.

decimal 0–255

8 (^H) Sets ASCII code for the back-

space character. Values greater

than 32 disable the backspace

character.