Royal Sovereign RSS-1050 用户手册

+

7. Set document on the table. 
   You should allow at least 5mm(1/4”) 

  space on each side for perfect laminations

8. Turn the switch “Run” and "take up motor"
   at the same time. The liner and film wii be

11. Turn off the power switch.

2. Pull COLD film, and fix it so that backside protecting paper can be wound on the take-u

5. It is                   when ready is show on the screen and the buzzer rings three times.

6. Turn on the take up device and set the proper film tension by pressing the              
    button. Lower tension would make better operation.

   mandrel clockwise. (Revolve core to make protectingpaper tight a little bit.)

3. Set pressure lever at the proper position following to your lamination condition.

4. After pressing the             button  choose and set proper speed by using the 
   and                                button.

1. Put cold roll film on upper bar.
   (Set the same as  method of HOT film for protect paper of lower part)

   rolled at the same time.

9. When the lamination is finished, press the                 button.
    For your convenience, it would be better to set table guide in proper position.

3. For worm lamination, set temperature from the hot mode.

    And if needed, cut documents with cross cutter.

10. Set pressure lever at the Hard board/1mm(40mil) mode.

1. Set up the protection paper. Otherwise, glue form the film will be stuck on the face of th
    and it can be seriously damaged.
2. Turn the switch “Run” and “Take up motor” at the same time.

C/HOT

SPEED

RUN

STOP

 

- 21 -