Royal Sovereign RSS-1050 用户手册

Rollers do not operate

1. Power cord may not be plugged

1. Check the power cord

 after press RUN 

    in.

2. Check the switch is on

 button.

2. Power switch is at OFF mode.

3. Check the emergency switch

3. Emergency switch may be at

    is off

    ON mode.

4. Release STND-BY switch by

4. It may stay at STAND-BY mode.

    press the STND-BY button

Heat shoe is not 

1. It is set at the cold mode

1. Change the function to hot

 heater up.

2. Memorized temp may be lower

    lamination.

    than atmosphere temp.

2. Set proper temperature for the
    work

*Noise from friction 

1. Film tension is too tight.

1. Adjust the film tension.

  between the shoe 

2. Temperature of heat shoe is too

2. Reduce the friction noise by

  and film is loud, while

    high

    adjusting temperature on the

  machine's operating

    heat shoes.

  at a slow speed.
*Wrinkled lamination

1. Film tension is not proper, too

1. Adjust film tension. 

  result

    tight.

2. Put the Idle Bar at right position.

2. Idle Bar in line with lower roller
    is not in proper position.

*Result of lamination is

1. Temperature on the heat shoe

1. Increase the temperature on the

  not clear

    is too low or lamination is too

    heat shoe or decrease the

    speedy.

    speed.

4. Bolt(M8X12) : 6EA

 

 

 

2. Fuse(50T) : 1EA

5. Washer-spring(Φ8) : 6EA

 

(AC 250V 6.3A)

 

 

3. Fuse(65TS) : 1EA

6. Bolt-core : 2EA

(AC250V 15A)

SPARE  PARTS

1. Core(76mm) :6EA

 

- 25 -