Royal Sovereign 1650 用户手册

1. Insert bar into the core of the roll film then place the bar on the machine.

2. Place the Pressure Lever (on the right side of machine) to the open mode at 15mm.

3. Insert a piece of wide cardboard (guiding paper/carrier) between the rollers.

4. Pull the film from the upper roller passing over the upper idle bar to the upper roller

    and put it on the roller. 

5. When temperature reaches 80℃（176°F）, resin starts melting and films turn to be

    transparent.

6. Place the film from lower shaft beneath the film from the upper roller which is already

    melting and unwind films of both rollers 30~40Cm(1~1.3ft) for loosing the tension.

7. Set the pressure Lever to the 1mm.

8. Set speed at 1 and press Run button. The films will be fed into the machine and will

    come out from the rear site of machine.

9. Check the status of lamination and place the pressure lever at lamination mode.   

UPPER ROLL FILM

UPPER IDLE BAR

HOT ROLLER

LOWER IDLE BAR

LOWER ROLL FILM

HOT METAL ROLLER

LOWER ROLL FILM

LOWER IDLE BAR

UPPER ROLL FILM

UPPER IDLE BAR

ROLLER

TAKE UP DEVICE

COLD FILM

TAKE UP DEVICE

COLD FILM

 

- 10 -