Royal Sovereign RSH-1151 用户手册

8

7

1. UPPER: To change upper roller temperature

by pressing button, then up or down arrow. 
(range 32~320°F or 0~160°C)

2. LOWER: To change lower roller temperature

by pressing button, then up or down arrow. 
(range 32~320°F or 0~160°C)

3. SPEED: To change speed of the rollers by

pressing button, then up or down arrow. 
(range 1 through 9)

4. MEMORY: To recall or change presets.

To recall the settings, press MEMORY then up
or down arrow.  To save the settings, set
desired temperatures and speeds then press
the MEMORY button twice. 
(stores up to 9 different settings)

5. C/HOT: To change the mode from hot to cold

or cold to hot lamination.  In cold mode, the
speed defaults to 2 (speed 1~ 9 settings) and
stand-by function is disabled.

6. T-CHECK: To check current upper and lower roller temperatures.Display automatically

returns to the previous settings after 5 blinks.

7. ST/BY: To change to stand-by mode (temperature will automatically reset to 176°F

(80°C).  While in this mode, all the buttons on the control panel are disabled.  Press
ST/BY mode button to resume normal operation.
NOTE: Auto stand by mode and auto power off mode
-Stand by mode:If no activity is made within 2 hours after each use the machine will
automatically switch into stand by mode.
-Auto power off mode:If the machine is in stand by mode and no activity is made for 60
minutes the machine will automatically power off.
-If any activity is made while in stand by or auto power off mode the machine will return
to it's previous stage.

8. REV: To reverse the rollers.  Must press and hold the button to activate.

9. STOP: To stop the rollers from turning.

10. RUN: To start the rollers .

11. RESET : To reset the substrate and length counters (option).

Press and hold RESET button for 2 seconds.

12. FAN: To activate the cooling fans.

13. MEAS: To display the substrate and length counters (option). 

Press button again to return to previous screen.       

1

1.3 (0.4)

1.5 (0.5)

2 

2.1 (0.7)

2.8 (0.8)

3

3.0 (0.9)

4.3 (1.3)

4

3.6 (1.1)

5.4 (1.7)

5

4.3 (1.3)

6.9 (2.1)

6

5.4 (1.7)

7.6 (2.3)

7

6.6 (2.0)

9.5 (2.9)

8

8.2 (2.5)

10.5 (3.2)

9

9.8 (3.0)

13.1 (4.0)

No.

Inches

Metric

(mm) 

1

Lamination

Lamination

2

1/25"

1

3

3/16 ~1/4"

5-7

4

3/8 ~1/2"

10-13

5

3/5"

15

NOTE: If you don't want to
laminate,please place the
pressure lever to the "Open
position(NO.5)".