Royal Sovereign RSL-2702 用户手册

RSL-2702

9.2. COLD LAMINATING

1. Put cold roll film on upper shaft. Load backing paper on the lower shaft as per

illustration 6.2 on page 7.

2. Pull COLD film and fix it so that the Release Liner can be wound on take-up

mandrel clockwise. (Revolve core to make Release Liner a little tight)

3. Set pressure lever to the proper position according to your laminating condition.

4. After pressing the button, choose and

set proper speed by using the and

button.

5. It is when ready is dispalyed

on the screen and beeps three times.

6. Turn on the take up device and set

the proper film tension by pressing

the

@??@h?

RUN "button. Lower tension

would make better operation.

7. Center the document on the table.

For ease and convenience set the

document guides in position

8. Press the

@??@h?

RUN "button and "take up motor" at the same time.The liner and film

will roll at the same time.

9. When lamination is completed, press the button.

10. Set pressure lever at the "OPEN" mode.

11. Turn off the power switch.

10. USING CROSS CUTTER

1. After lamination, move the cutter

approximately to the center of the
completed application at the desired point
of detachment (Figure 1).

2. Grasp film with one hand, press the cutter

downward into the application and slide it
first to one end of the application, then to
the other end to complete the cut.
(Figure 2 & 3)

Figure 1

Figure 2

Figure 3

The cross cutter is located on the rear exit table of the machine.